SYNTECH HAG ACRYL - Добавка и смола для гидроизоляции

Syntech HAG Acryl is a four-component resin that reacts to form an elastic and durable gel.‎ The properties of Syntech HAG Acryl are:  Good general chemical resistance.‎  Does not contain acrylamide, methacrylamide, formaldehyde or solvents.‎ Not inflammable.‎ Excellent adhesion on mineral building materials such as concrete, cement and bricks.‎ The reaction speed can be adjusted from a few seconds to several minutes.‎ When the injected cracks dry out due to temperature or groundwater level fluctuations the gel does not crack easily.‎ The hardened gel has excellent durability in wet-dry cycles.‎ COMPONENTS Four-components APPEARANCE Liquid + Powder Features and benefits: Syntech HAG Acryl Syntech HAG Acryl components are supplied ready to use.‎ Create 2 mixes in separate plastic buckets.‎ Prepare only the quantity to be used each time.‎ Solution 1: Syntech HAG Acryl component A (25 kg resin) mixed with Syntech HAG Acryl component B (2.‎5 kg catalyst).‎ Solution 2: Syntech HAG Acryl component C (2 packs of 0.‎625 kg) mixed with clean tap water.‎ Attention: The amount of water must be equal in volume to solution 1.‎ When mixing resin, always use a wooden or stainless steel spatula.‎ The reaction time depends on the temperature of the material, the structure of the building and the possible amount of water present.‎ Higher temperature will speed up the reaction time and lower temperature will slow it down.‎ It is advisable to carry out an on-site test, before injection, to observe and define the reaction time.‎ To change the reaction time, only adjust the amount of Syntech HAG Acryl component C.‎ The amount of the other components remains the same.‎ Use a two-component stainless steel pump (manual, electric or pneumatic).‎ Check that the pump and equipment are clean and that there is no residue from previous injection work.‎ The two mixtures are fed into the pump separately, but are mixed homogeneously at a volumetric ratio of 1:1 in the pump's mixing head, before being injected through the pump nozzle.‎ Check the quality of the concrete, as injection involves pressure.‎ Fields of application Sealing and waterproofing of cracks and cavities in walls, floors, concrete constructions, underground structures, etc.‎ It can be used in constructions that are not permanently in contact with water (fluctuating groundwater level).‎ Injection of very fine cracks.‎ SYNTECH is a line of polyurethane and polyurea resins and epoxy compounds.‎ Further info from manufacturer on SYNTECH HAG ACRYL Azichem