SLIVER - Вытяжка из стали с сенсорным управлением

SLIVER adopts patented solutions to heat not only the flap that can be opened, but all the lower surfaces of the hood immediately after being turned on, bringing them to a certain temperature that avoids the formation of condensation.‎ If this were not the case, unheated parts such as inclined filters of other products on the market would inevitably produce drops on the surface.‎ The captured air, still full of humidity, passes through cold surfaces inside the hood where it releases the contained water which is then collected in an internal tray.‎ This internal tray contains electronic sensors that continuously monitor the water level, stopping the hood motor as soon as the level reaches the maximum.‎ The command LEDs flash to signal this condition.‎ The emptying of this tray is very simple and fast and is performed by pressing a lever and placing a glass under the drain valve.‎ Only after emptying the tray will the hood work again.‎ SLIVER has been tested in laboratories in the most critical conditions, with 4 boiling pots and at a distance of 50cm.‎ from the induction hob.‎ Even in this extreme condition, after more than an hour of operation, no drop falls into the induction hob below.‎ SLIVER is the only one to prevent the formation of drops in all its surfaces and therefore prevent them from falling on the induction hob below.‎ Finishing: Inox / Anthracite Version: Duct out Controls: Electronic Soft Touch 3S + B Lights: LEDSTRIP 4Wx60cm, 6Wx 75/90/120cm-3000K Max airflow: 635 m3/h Total absorption: 426 W Sound power: 63 dB(A) Energy Class: A Further info from manufacturer on SLIVER Galvamet