ONDULINE ITALIA ONDUCLAIR PLR

ONDUCLAIR PLR - Roof panels and rolls in translucent plastic laminates reinforced with glass fibre for roofing and cladding.‎ ONDUCLAIR PLR products are made from glass fibre reinforced polyester resin, in compliance with EN1013-2.‎ The combination of the fibres with the resin gives the sheets excellent mechanical strength and excellent chemical and thermal stability.‎ Both surfaces are protected by 'gel-coat'.‎ FEATURES Time-saving installation: optimised transport, with sheets up to 12 m long Quick and easy installation Easily adaptable to any configuration Improved well-being thanks to soft light and double UV protection Long life: excellent resistance to hail and natural corrosion Wide design freedom Lightweight UV-resistant Impact-resistant Easy to lay Fields of application ONDUCLAIR PLR translucent sheets and rolls are intended for use as lighting parts of roofing or cladding, of all types of constructions (residential, industrial, agricultural, etc.‎).‎ With reduced light transmission compared to transparency, ONDUCLAIR PLR products offer diffuse and wide illumination.‎ Technical characteristics GO 110 Thickness:9/10 mm Dimensions: 152 x 110 cm and 214 x 110 cm Colours: Crystal Light transmission:85%.‎ Warranty: 10 years Complies with EN1013-2 Laying Fixing is carried out by means of screws, of a model and length appropriate to the type of support, with a suitable gasket with washer in between, which will guarantee the mechanical and infiltration seal.‎ Plastic spacers can be inserted in the vicinity of each fixing, underneath the waves.‎ Start laying the slabs with a projection along the eaves line of max.‎ 7 cm.‎ The laying sequence must be carried out in the direction opposite the prevailing winds.‎ It is recommended that the slabs are drilled before fixing them.‎ To accommodate the phenomenon of natural thermal expansion of the slabs, drill a hole twice the diameter of the screws.‎ The transverse overlap between two slabs is 20 cm, while the longitudinal overlap is made by overlapping 2 waves.‎Near the eaves line, carry out one fixing every wave.‎ For the rest of the roof, carry out one fixing every two waves.‎ Calculate approximately 8-10 fixings per m2.‎ Minimum slope of the roof: 15%.‎ The maximum distance between supports is 110 cm.‎ ONDUCLAIR is the ONDUCLAIR range of translucent covers made of polycarbonate and polyester.‎ ONDUCLAIR is synonymous with brightness, resistance and reliability.‎