Faresin Formwork - Лифт-шахта

The LIFT SHAFT shaft consists of the module formwork of both 100/120/light profiles and four biconical blocks placed in the inside corners.‎ In the outer corner, formwork joined in the traditional way is used: clamps or pin and wedge, while the universal clamp is used for the corner.‎ For the next casting, it will be sufficient to slide the biconical blocks, placed in the corners, between them to facilitate dismantling and subsequent use.‎ The upper casting will be carried out using formwork support brackets positioned on the previously realised bar passage hole.‎ The Lift shaft is realised using biconical blocks on the inner formwork and standard formwork, which allow the complete formwork to be slipped off, also suitable for manholes and manhole covers of any size.‎ DIMENSIONS BICONIC BLOCK From 4500X250X250 to 2700x250x250 mm (From 14' 9" 11/64 x9" 27/32 to 8' 10" 19/64x9" 27/32x9" 27/32) BICONIC BLOCK APPLIED TO TRADITIONAL WOODEN SYSTEM From 1500 to 3000 mm (From 4' 11" 1/16 to 9' 10" 7/64) SHEETWOOD COMPENSATION From 1500X150 to 1350X300 mm (From 4' 11" 1/16x5" 29/32 to 4' 5" 5/32 x11" 13/16) FIXED CONICAL INNER CORNER From 1500x250 to 1350x250 mm (From 4' 11" 1/16x9" 27/32 to 4' 5" 5/32x9" 27/32) Further info from manufacturer on LIFT SHAFT Faresin Formwork