BETON_LED - Плитка
BETON_LED is a new production method, patented by CEDA, that allows a LED (Light Emitting Diode) type light source to be permanently applied to vibrocompressed concrete artefacts. This great innovation makes it possible to have new products available for use in the most diverse architectural contexts, where previously only 'recessed' type light sources could be used, and therefore more or less in relief, but now with great time savings and at a competitive price.
The
advantages of BETON_LED
The strength of a choice:
LEDsLED light sources are characterised by their astonishing performance:
-
long life and reliability (over 70,000 hours) and no need for scheduled maintenance. The LEDs used are waterproof (IP 65) and therefore protected against any possible infiltration;
- low electricity consumption compared to normal incandescent light sources, with the same lighting conditions;
- high brightness and brilliance of the light emitted;
- fast switching, even at low temperatures;
- reduction of CO2 emissions into the atmosphere, with great attention to the environment and to the limited resources available;
- high safety even in the presence of water thanks to the low operating voltage.
The light source is 12V powered and can have different light output (60 or 120 lumens) depending on the design requirements that emerge. Their consumption is low: the 60 lumen source consumes about 0.8 Watts.
Ideal in every architectural project1
. Roundabouts and junctions to highlight routes in poor lighting conditions
2. Car parks and pedestrian paths for effective route definition
3. Footpaths and traffic islands for better signalling of obstacles
0
0
