ELCOM SYSTEM - Трапециевидные листы LG450

Corrugated Sheets LG450 - Facade Panels.‎ Metal supports Corrugated sheets can be made of: • Carbon steel coated with a layer of zinc applied continuously by hot immersion in compliance with UNI EN 10147 standards with mechanical characteristics not inferior to those of the steels provided for by the Ministerial Decree of 09/01/96; • Stainless steel whose characteristics are defined by UNI 10372 standards; • Aluminium with a minimum breaking load of 150 MPa, UNI 10372 standards; • Copper with mechanical characteristics and physical state defined by UNI EN 1172 standards.‎ After degreasing and pre-treatment of the surfaces, depending on their nature, a primer coat with a thickness of 5 microns is applied to the support strips by roller; after the relative baking at approximately 220/250°C, a finishing coat is applied.‎ Different coatings can be supplied on request.‎ The possibility of special processes such as cambering and drawing allow the use on any type of construction.‎ Steel modulus of elasticity E = 210000 N/mm² The Trapezoidal Sheets of Elcom System s.‎p.‎a.‎ (company with UNI EN ISO 9001:2000 certification) have been researched to make roofing, wall and floor slab.‎ The possibilities of particular ways of shaping such as cumbering and drawing allows for their use in every kind of building.‎   Further info from manufacturer on Trapezoidal Sheets LG450 ELCOM SYSTEM