BITUVER RENOVER XTRA - Мембраны для гидроизоляции

BITUVER RENOVER XTRA waterproofing membranes are specially designed for re-roofing with an exposed bitumen polymer membrane.‎ Certified for single-ply use.‎ Cold flexibility -20°C The underside is made from a specific elastomeric SBS compound that ensures very high adhesion (no need for other adhesion promoters to fix the slate and even out the laying surface).‎ The top side in innovative APAO compound, on the other hand, is fine-tuned to allow high application efficiency, strong reduction of blemishes during laying, and excellent UV resistance.‎ The reinforcement consists of spunbonded non-woven polyester fabric.‎ The membranes are also available in the California version with SRI medium wind 55 Solar Reflectance 0.‎48 Uses BITUVER RENOVER XTRA membranes in the Mineral version are used as single-layer waterproofing and as a finishing layer.‎ Various Application - Use the PPE required by law; - Properly clean the substrate and assess its condition; - BITUVER RENOVER XTRA is designed to restore waterproofing to polymer bitumen membranes at the end of the cycle, on roofs where the lower layers are well bonded to the slab and have no interstitial infiltrations.‎ The feasibility of this operation must be assessed on a case-by-case basis after careful analysis of the roofing and underlying layers, if necessary using sample cores; - BITUVER RENOVER XTRA is suitable for torch application by heating the lower face coated with a special thermofusible film with a propane gas torch; - Always apply between +5°C and +35°C.‎ Storage Keep rolls in storage, out of sunlight and at a temperature not below +5°C.‎ Keep the rolls in an upright position.‎ Avoid overlapping pallets if possible.‎ We recommend using the product within 2/3 months after delivery.‎ Further info from manufacturer on BITUVER RENOVER XTRA Saint-Gobain - ISOVER