PLASMACEM LINEAR

Maximum single piece dimensions: base mm 1000 x height mm 3000.‎ Available in Polyurethane for 50 uses.‎ Available in Elastomeric for 100 uses.‎ FEATURESPRODUCED MATERS The company supplies matrices with special designs not included in the basic supply, made with the same mechanical and technical characteristics.‎ USE STONCLEAR matrices are simply inserted between wooden or iron moulds and fixed with classic spacers.‎ We recommend the use of our special release agent.‎ For masonry up to one metre in height (see adjacent photo) PLASMACEM will supply the matrices with a light frame that will make them self-supporting.‎ For masonry more than 70 cm.‎ thick, it is recommended that they be removed within 24 hours.‎ There are no special requirements for their storage on site, they can withstand high temperatures as well as cold climates, and there is no need to store them in areas protected from atmospheric agents.‎ The STONCLEAR series matrices are therefore to be considered not only an exclusive product which allows you to create aesthetically performing ostrich lime surfaces, but also a real piece of equipment which implements building capabilities.‎ SUPPLY AND STORAGE The STONCLEAR series matrices are supplied in pallets of max.‎ 25 pieces for a maximum footprint of 1 cu.‎m.‎ No trimming is necessary when used.‎ There are no particular problems in handling them, which can be done either by hand, given their low weight, or with the aid of forklifts for the complete pallet.‎ The only care to be taken when unmoulding is not to use sharp elements to facilitate detachment of the die from the part.‎ CUSTOMER SERVICES If test castings are required, PLASMACEM SRL will send the customer a die for inspection.‎ To obtain a price list of the basic products in production and/or an estimate for any type of finish, simply send an e-mail to info@plasmacem.‎com.‎ The sales department will provide a reply as soon as possible.‎ PLASMACEM SRL also provides an on-site consultancy service on request for the first use of the dies.‎ The cost of this service will be established directly with the customer.‎ Form liners for architectural concrete by PLASMACEM Using form liners for architectural concrete allows you t • Create patterns on exposed concrete walls.‎ • Adapt buildings to meet all aesthetic needs.‎ • Obtain even surfaces in a simple and cost-effective manner, thanks to the play of light and shadow that can be generated.‎ STONCLEAR Form liner for casting in situ • form liners in cyclic density polyurethane, fortified by synthetic resins.‎  • 3 - 100 reuses.‎  • fixing to formworks with glue or screws.‎ • fixing to plastic formworks with magnets.‎ • improved pull-out assembly.‎ To achieve the best results, we recommend that you: • Use class S4 concrete and a suitable superplasticizer.‎ • Use a concrete recipe suitable for exposed surfaces.‎ • Store in a dry place protected against direct exposure to frost, sun, and rain.‎ The form liners by Plasmacem are delivered to size taking into account the information on construction site requirements.‎ The dimensions of the products delivered are guaranteed with a tolerance of ± 0.‎5%.‎ The concrete release must take place within 24 hours of the casting.‎