Winkler ONE® FLOORING - Жидкая водонепроницаемая мембрана

ONE® FLOORING is a single-component coloured liquid waterproofing membrane with high UV-resistant protection specifically formulated to ensure long-lasting waterproofing, and durable ‘drive-over’ protection to treated substrates.‎ Applicable both indoors and outdoors in extreme conditions: low and high temperatures (from 0°C to +45°C), on damp, very humid or wet substrates.‎ The product remains stable to thermal shocks.‎ Specific for waterproofing and protecting floors also subject to strong stresses, such as: garages, parking lots in general, industrial floors, cement screeds that are not completely cured (e.‎g.‎, 7 days at 15°C), substrates in: concrete, tiled and with permanent problems of excess moisture.‎ The product, when fully cured, is resistant to wear from the passage of rubberized vehicles, even intense and hard tyres.‎ Its particular formulation allows optimal adhesion, even on asphalt substrates, as long as it is compact and with good mechanical strength (≥ 0.‎5N/mm²).‎ Once applied, after a few hours it is completely out of the rain (refer to the table on the technical data sheet).‎ APPLICATION It can be applied with a spatula or short-haired roller.‎ Apply the first coat with about 80% of the consumption described in the technical data sheet and the remaining 20% in the second coat (e.‎g.‎, 1.‎8 kg/m² in total = 1.‎45 kg/m² first coat - 0.‎35 kg/m² second hand).‎ The use of the spiked roller for the first coat is always recommended.‎ For any repairs to the surface, PRE-ONE mortar or UNIBAR FORMULA and UNIBAR MALTA can be used.‎ In case of an oil-polluted substrate, provide for the use of ONE PRIMER or TECHNOASFALT where applicated on asphalt (see technical data sheet).‎ In case of application on substrates subject to movements, it will be necessary to interpose ONE MAT in between.‎ CONSUMPTION 1.‎7 - 1.‎9 kg/m² without reinforcement.‎ 1.‎8 - 1.‎9 kg/m² with the interposition of ONE MAT.‎ USEFUL ADVICES Make sure that the supports are clean and free from crumbly, detached parts, foreign or non-sticking substances.‎ Apply in two coats.‎ To obtain an optimal finish, apply the second coat of the product with a short-haired roller both longitudinally and transversely.‎ SURFACES WITH JOINTS: The joints must always be respected and waterproofed with a suitable polyurethane sealant.‎ PACKAGING 10 - 20 kg buckets.‎ COLOURS light grey - grey - red -green (white and yellow for signs).‎ STORAGE The product, in its undamaged packaging and stored in a dry and protected place, has a shelf-life of 12 Further info from manufacturer on ONE® FLOORING Winkler