Bacchi - Сетка для штукатурки

For correct use of the fibreglass mesh for plaster, it is necessary to lay it over about half/two thirds of the layer of plaster that is still fresh, making sure to overlap the sheets by about 10 cm.‎ The final layer of plaster can then be applied, taking care to completely bury the support mesh.‎ RETEPER INTONACI CERTIFICATA RETE PER INTONACI CERTIFICATA RETE PER INTONACI, certified ETAG 004, grammage 155 g/m2 c.‎a.‎ and mesh size 4.‎0 x 5.‎0 mm.‎ It is used in plasters and coatings to ensure an adequate uniformity of the finish while avoiding possible cracks caused by shrinkage during hardening.‎ Finishing with anti-alkaline materials also ensures excellent durability.‎ Mesh produced according to the most recent standards and ETAG 004 certified, i.‎e.‎ it complies with the European Commission's guidelines on the suitability of this product for use in the building industry.‎ RETEPER INTONACI 10X10 Glass fibre mesh 10x10 mm density 125 g/sq.‎m.‎ c.‎a with anti-alkaline treatment for use in repairing thickened plaster, especially where higher grain sizes are used, and is generally ideal for absorbing and evenly distributing the mechanical stresses to which the plaster may be subjected due to shrinkage, temperature excursions, settling, external agents, thus preventing the formation of cracks in the façade.‎ Given its mesh size, it can also be used on the floor.‎ Available in boxes of 4 rolls.‎ NETFOR LIGHT FINISHING AND SHAVING Glass fibre mesh 5x5 mm density 75 g/sq.‎m.‎ approx.‎ with anti-alkaline treatment for light finishing and shaving, ideal for preventing the formation of cracks and fissures in gypsum-based finishes and at joints between substrates of different materials.‎ It can also be used as reinforcement for plastics and waterproofing.‎ Available in boxes of 6 rolls.‎