VMZINC PLUS® - Непрерывный металлический ламинат для крыши

VMZINC PLUS® is a special titanium zinc laminate to which a thin layer of protective lacquer (60 μm thick) is applied on the underside by means of an oven-curing process.‎ This production process, patented by Umicore, ensures that the laminate can be laid on any substrate, even if it is incompatible with titanium zinc and in the absence of ventilation.‎ VMZINC PLUS® is specific for non-ventilated roofs and non-compatible substrates.‎ It also allows for the creation of complex architectural shapes that cannot normally be achieved with traditional ventilated layers.‎ Advantages - no need for traditional ventilation - compatibility with all types of substrate - high corrosion protection and long life even under extreme conditions Applications - non-ventilated roofs for high hygrometric conditions - complex shapes - large surfaces - all types of climates, even the most extreme - all types of geometries curved, concave and convex, conical, geodesic.‎ - All types of wooden substrates - All types of metal substrates - Reinforced concrete slabs Main data VM ZINC PLUS® Surface appearance Natural pre-patinated QUARTZ ZINC®, ANTHRA-ZINC® and PIGMENTO® Thicknesses: 0.‎7 and 0.‎8 mm Coil widths: 500, 670 and 1000 mm Seam spacing: 430 mm and 600 mm ApplicationVM ZINC PLUS® Applications Non-ventilated roofs for high hygrometric conditions Complex conformations Large areas All types of climate, even the most extreme Roofing types All types of geometries: curved, concave and convex, conical, geodesic Permitted substrates All types of wooden substrates All types of metal substrates Reinforced concrete slabs Slopes Slopes > 5% (3°) Installation Use of strips up to 15 m for slopes from 5% to 60%, up to 10 m for slopes greater than 60%.‎ Profiling and mechanical seaming of strips.‎ Finished longitudinal joint 25 mm high and 5 mm thick.‎ Transverse joints depending on slope.‎ Fixings Fixed and sliding clips in stainless steel VM ZINC® profile 1, placed at a maximum distance between centres of 33 cm, inserted in the longitudinal joint.‎ A band of 5 fixed clips will anchor the cladding, while on the remaining surface the arrangement of the sliding clips will guarantee the thermal expansion of the laminates and, therefore, the flatness of the cladding.‎ At the edges of the pitches, the first 3 clips are placed at 16.‎5 cm centres to counteract wind forces.‎ Accessories Complete range of all finishing sheets.‎